XRF Serie
The Maassen Die Set Series XRF is simplifying your sample preparation! With the spring-suspended base, combined with different adapters for different analysing instruments, you are able to press samples in a very short time.
The adapters enable to use steel rings or alu-cups in different sizes. You fill in your sample, put the lid on the sample and move it a bit to get a consistent surface and then press it with up to 40 tons.
They are available in four different versions:
Model XRF-BR51
This Die Set is made for steel rings with 8 - 9 mm height, an outer diameter of 51 mm and inner diameter of 35 mm. It is made of the base unit XRF-B combined with the adapter XRF-51.
Model XRF-BC40
This Die Set is made for Aluminiumcups with 40 mm (usually 39.8 mm) diameter. It is made of the base unit XRF-B combined with the adapter XRF-40
Model XRF-BR4035
This Die Set is made for steel rings with 14 mm height, an outer diameter of 40 mm and inner diameter of 35 mm. It is made of the base unit XRF-B combined with the adapter XRF-R4035
Modell XRF-BR4032
This Die Set is made for steel rings with 14 mm height, an outer diameter of 40 mm and inner diameter of 32 mm.
Construction
The tool itself consists in total of 5 elements plus an extraction ring (not shown). The three-part base (3) is already pre-assembled and spring-mounted. Depending on the type of pressing tool at hand, as mentioned, a slightly different cylinder is used in order to be able to press into different rings or aluminum cups. The top part always consists of two elements: a ring (2) and a cover (1). Both have a red marking that points towards each other when assembled correctly. The models BR51, BR4035 and BR4032 also include two spacers (4) and an Allen key.
The following video shows the application of the XRF-BC40 variant in use with our motorized laboratory press MP250M.
(Video)